Gold Canyon, AZ

View visual findings from this job here - https://visionshare.xoi.io/?id=XA-6E7D-D3C1EA4F45354383B98B3D117763BDB1

Arrived on site and found thermostat set to 72 but 76 inside. Found condenser with faulty capacitor and burnt starter (contactor). Mary approved the repairs and I completed repairs at condenser. Checked operation and found system cooling. System from 2005 and using R22 refrigerant.

Completed installing new compressor also installed two surge protectors One on each unit when George gets back into town we still have two breakers to replace

Residential Air Conditioner Repair: Completed a residential air conditioner repair to resolve cooling issues. The system was experiencing reduced cooling efficiency, leading to discomfort in the home. Diagnosed the problem, which was a faulty compressor capacitor, and replaced it. Conducted a comprehensive system check, ensuring all components were functioning correctly, resulting in restored cooling performance and improved comfort for the homeowner.

Had a surge took the compressor out. On the other unit out called all items are on warranty at this time. All items on order threw trane supply in mesa will be in on Monday.

Upon arrival found system cooling. Checked complete operation of equipment. Found outdoor fan motor with signs of oil leakage and pulling .61 amps when rated for .60. Right now it’s 80 degrees outside. When it gets hotter or the system runs for a longer period, it’s very likely that this motor is failing causing the system to not cool correctly. It’s possible that the parts will be covered under warranty. Need to contact provider on Monday and return to replace outdoor fan motor and capacitor. See estimate for pricing.

Had to add 2 pounds of refrigerant on the unit we did not do anything to the unit with the new compressor has a 10° of coal it calls for an 8+ or -3 the other unit cost for a 10° of cool and was at eight put unit back to 10 sub cool both units are cooling within manufacture specs

Upon arrival installed to ecobee thermostats. a Remi halo. and a safety switch on the other units are running within manufacture specs at this time

Changed drain pan added condensate switch cleared drain line coming back tomorrow to put in 2 Wi-Fi thermostats customer has 2 units to be covered under maintenance plan

Replace dual run capacitor up to 80+5 mfd. Test all operations to ensure system part is working properly while system is running.

We will be sending a quote for a 2 ton mini split customer is ready to get this done as soon as possible advised him most likely Monday or Tuesday The garage is 38 feet long by 35 foot 1330 square ft with 9 1/2 tall ceilings

Upon arrival found system in off position at thermostat. This unit was installed recently and has an issue with the drain. The installing contractor came back and made a correction to the primary drain line. There is a water gurgling noise coming from the duct work in the floor but I did an inspection of the duct work at the main return and the secondary return and found no water at this time. Under the unit is wet and has signs of water being there but is dry at this time. There are various things that need to be done to better the installation and make sure everything is working safely, efficiently and draining properly. Recommend keeping the fan button at the thermostat to the ON position for the next 48-72 hours to help evaporate water in the duct work and under the unit. Keep the system in cooling mode to help dehumidify the system. 1. Found sub cooling slightly low. System cooling with 27 degree split at this time. I’d like to let the duct dry out and re-check charge

Upon arrival compressor was reading 22 out of 23 swapped out compressor with a new one compressor is now reading at 16unit has a 9.4 degree sub cool all within manufacture specifications

Daikin split heat pump Inverter system System qualifies for SRP rebate of $225 per ton. SRP will send you a rebate check in the mail for $675 in 4-8 weeks. System comes with a 12 year warranty and 12 year unit replacement through Daikin. 2 year labor warranty through All Out. Scope of work 1. Protect home with floor covers and drape plastic in closets and pantries as needed. 2. Remove & Replace existing split system with new AHRI rated split system with air handler in the attic. 3. Supply & Install custom uni-strut hangers to support system/drain pan. 4. Supply & Install a new Goliath Dexelar secondary drip pan with vibration isolators. 5. Supply & Install new custom fabricated duct distribution boxes (plenums) matched & sealed to the flange of the air handler to prevent air leaks. 6. Supply & Install new manual dampers on every supply duct off of the plenum. 7. Supply & Install condensate overflow safety switch. 8. Supply & Install new condensate EZ-trap with cleanouts an

August 2 2023 Removal of old equipment and installation and start up of new equipment. August 3 2023 Returned with data loader needed for complete start up of equipment. Started up and checked for proper operation. System working correctly at this time. See photos

Homeowner is going to need a new compressor for this unit I got the actual compressor number and I will upload the photo and look getting a quote set for the home owner

Installed all new warranty items unit is up and cooling

Upon arrival had to adjust refrigerant levels subcool was extremely high unit is running within manufacture specs at this time no service charge per George

System is working properly at this time. Meets all manufacture specifications. Also cleaned outdoor condenser coil.

Both systems are working properly at this time. Meets all manufacture specifications.

Upon inspection I found both condensers to be working properly. All run capacitors are running within tolerance. Air handler in attic is working properly. Run capacitor is running at 19.2 and rated for 20. Air handler in garage has a run capacitor running at 11.2 uf and rated at 15 uf. There is a tolerance range of 10% +/-. I cleaned outdoor condenser coils with hose.

Upon inspection I found the system to have no Freon in it. I pressure tested system and could not find a leak. I then put system into a vacuum to 400 microns. No leak present. Charged system and system is working properly at this time. No charge, under warranty.

Existing system in sitting on wood in attic over emergency drain pan that is rusted through. Hang system and replace drain pan. Add return plenum. Performed listed work and checked operation. Found system working correctly at this time. See photo.

Perfomred Pma on 4 systems. One mini split in garage with condenser on roof. Three split heat pumps with air handlers in attic and condensers on ground. Found faulty contactor on north unit. Also will need to return to rehang system, add return pleunem and change out secondary drain pan. Changed contactor while on site. Will also need to re work drain on air handler serving main house and add clean out to unit in attic serving master bedroom. Will need to return. Please schedule return date with Troy no later than 2 weeks from today.